A common comparison measuring system for holes ranging from

Approximately $0\mathrm{.}5$ to $6\mathrm{.}00$ inches would be :$-$

a$)$ Telescopic gage and micrometer

b$)$ Binocular gage and scale

c$)$ Dial bore gage

d$)$ Small hole gage

Calculate RPM for a $0\mathrm{.}5$ inch drill diameter and cutting speed of $200$ SFPM$.$ Use the short RPM formula.

a$)1528$

b$)3200$

c$)1600$

d$)1527$

Cutting Aluminum using $\frac{1}{2}$ inch End Mill cutter with CS $($cutting Speed$)$ Of $600$ SFPM the RPM is using the Long Formula:$-$

a$)3819$

b$)4000$

c$)4583$

Which is the correct sequence for drilling a hole on the drilling machine?

Where Pilot drill hole is $"1"$

Centre Punch is $"2"$

Center Drill is $"3"$

Height gage to mark line $"4"$

Final drill to size $"5"$

a$)1,2,3,4,5$

b$)4,2,3,1,5$

c$)2,4,3,1,5$

d$)3,2,4,5,1$

When using the Vertical Milling Machine and moving the $"z"$

Axis $.$One revolution of the $"z"$ axis moves the table's height:$-$

a$)0\mathrm{.}010$ inch

b$)0\mathrm{.}100$ inch

c$)1\mathrm{.}000$ inch

When carrying a long load it is advisable to carry it:$-$

a$)$ By your side

b$)$ On your Shoulder

c$)$ By kicking it

d$)$ On your Head

The Feed Rate on a Milling Machine is expressed in:$-$

a$)$ Feet per Minute

b$)$ Inches per Second

c$)$ Inches per Minute

d$)$ Inches per Tooth

The Cutting Speed for HSS tool is than a Carbide tool.

a$)$ Lower

b$)$ Higher

c$)$ The same as

d$)50\%$

To align a Vice on a Milling Machine Table $?$

a$)$ Indicate the Solid Jaw

b$)$ Measure the Vice Jaw with a steel rule

c$)$ Place the Vice against the stops in the table $"$T$"$ slots

d$)$ Indicate the adjustable jaw