Question: A cone penetration test was conducted on soil samples. The results of penetration depths in mm were compared against the water content % values of

A cone penetration test was conducted on soil samples. The results of penetration depths in mm were compared against the water content % values of the soil. The relationship between depth of penetration (d) in mm and water content (w)% was found to be d=0.56w +5.47. What is the liquid limit of this soil?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

$7,500$7,847Mark for follow upQuestion 2 of 49.What is the amount ef Catherine's refund?$984$4,587$10,752$14,355Mark for follow up

Q:

Help ASAP Laboratory la Introduction Soil differs from other engineering materials in that usually there is no control over its structure, properties or behaviour in the ground. In site investigation...

Q:

Please let me know if you need anything, thank you. 2a. Schematically illustrate the subsurface conditions and calculate the effective vertical and total horizontal stresses at Point A before...

Q:

Hello, you already did chapter 1 and 2 of my MASTERS Thesis already for me. (See attached) So normally you know masters thesis consist of 5 chapters right ??..... But in this case my thesis will be 4...

Q:

Question: 1)Reflect back from everything you have learned from this notes and write a summary: 2)Decide what your 2 or 3 most-important "Lessons Learned" are: MRK108 Midterm Notes Chapter 1: Product...

Q:

In a cone penetration test on a fine-grained soil sample, the following results were recorded. Test No. 1 2 3 4 Cone Penetration (mm) 11.76 14.75 17.96 22.77 Mass of Container (g) 10.07 9.91 9.93...

Q:

A cone penetration test was carried out in normally consolidated sand, for which the results are summarized below: Depth (m) ........................ Cone resistance, q c (MN/m 2 ) 2.0...

Q:

For the data given in Problem 3.22, if D 50 = 0.8 mm, find the N 60 values at each depth. Use Eq. (3.55) with Kulhawy and Mayne values for a and c. Eq. (3.55) Problem 3.22 A cone penetration test was...

Q:

7. A cone penetration test on a coarse-grained soil with mean particle size (D50) of 0.5 mm produced a cone resistance (qc) of 80 kg/cm2 and a friction ratio (Rf) of 1%. [5 points]

Q:

For the data given in Problem 3.22, determine the relative density at each depth using Eq. (3.51). Assume moderately compressible sand and hence Q c = 1. Eq. (3.51) Problem 3.22 A cone penetration...

Q:

A cone penetration test was conducted in a layer of saturated clay. The cone tip resistance, qc, at 6.7 m below the ground surface was found to be 1245 kN/m2. If the unit weight of the saturated clay...

Q:

You are considering two investment options. In option A, you have to invest RM3000 now and RM1000 three years from now. In option B, you have to invest RM2500 now, RM1500 a year from now, and RM1000...

Q:

The Daniels Tool & Die Corporation has been in existence for a little over three years. The company's sales have been increasing each year as it builds a reputation. The company manufactures dies...

Q:

Machine Corporation buys a business van in State V and pays 6 % sales tax. The van is used in State W by Machine. State W has a 9 % sales tax. Because of this transaction, State W is likely to impose...

Q:

n Intergenerational external cost associated with an open access fishery is borne by both current and future generations. caused by underfishing of the stock. borne by the current generation. borne...