Question: A cylinder is 1 0 ft long with a diameter of 3 ft . It has an internal pressure of 8 0 0 0 psi.

A cylinder is 10 ft long with a diameter of 3 ft. It has an internal pressure of 8000 psi. What is the maximum wall thickness if the maximum allowed longitudinal stress is 6,000 psi? (Assume that a safety factor has already been included in the maximum longitudinal stress value.)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

The following selected accounts and their current balances appear in the ledger of Clairemont Co. for the fiscal year ended May 31, 2016: Cash Accounts Receivable Inventory Estimated Returns...

Q:

In one of the shops, there are some cylinders stored. Questions have been asked as to how they know the cylinders are safe, what happens if there is a change in temperature, etc. You decide you may...

Q:

Procedures: Pressure on suction and discharge side of a single pump was measured with the corresponding flow rate over a range of pressures (the pressure will be varied by adjusting a valve). For the...

Q:

This print-out should have 34 questions. Multiple-choice questions may continue on the next column or page - find all choices before answering. 001 10.0 points Find the interval(s) where f(x) = 2-...

Q:

2.2 A small closed cylinder has dimensions 50 mm external diameter by 160 mm long with 0.25 mm wall thickness. (a) What is the allowable internal pressure if the safe tensile stress for the material...

Q:

For the drying oil process shown in Appendix B.4, check and validate the design specifications for the following three pieces of equipment against the appropriate heuristics: P-501, H-501, V-501. Use...

Q:

18 1. Gold is sold by the troy ounce (31.103 g). What is the volume of 1 troy ounce of pure gold? 2. A straightforward method of finding the density of an object is to measure its mass and then...

Q:

Question 5 (10%) Determine the horizontal displacement of the roller at B and the vertical displacement at C of the steel truss system illustrated in Figure 5. The members are made of steel with the...

Q:

Computer Science Question 1 : Heat Exchanger Design Part A: Calculate the heat transfer rate required for a heat exchanger to cool 1 5 0 0 kg / hr of water from 8 5 C to 3 0 C . Assume the specific...

Q:

Computer Science Question 1 : Heat Exchanger Design Part A: Calculate the heat transfer rate required for a heat exchanger to cool 1 5 0 0 kg / hr of water from 8 5 C to 3 0 C . Assume the specific...

Q:

computer Science Question 1 : Heat Exchanger Design Part A: Calculate the heat transfer rate required for a heat exchanger to cool 1 5 0 0 kg / hr of water from 8 5 \ deg C to 3 0 \ deg C . Assume...

Q:

1. Which of the units of the following physical quantities is not a derived unit? A. magnetic flux C. electric charge D. mass E. time B. tension 2. Each of the following physical quantities is...

Q:

A soap bubble (n = 1.33) is floating in air. If the thickness of the bubble wall is 115 nm, what is the wavelength of the light that is most strongly reflected?

Q:

Which of the following calculates the length of time required to earn back the amount of the initial outlay for a capital expenditure? Multiple Choice Payback method Internal rate of return method...

Q:

Create a plan and implement effective change within a Health and Social Care organisation 2 answers