Question: Design a first-order active low-pass filter with a cutoff frequency of 2 kHz and a gain of 40dB for implementation in a digital stethoscope.

Design a first-order active low-pass filter with a cutoff frequency of 2

Design a first-order active low-pass filter with a cutoff frequency of 2 kHz and a gain of 40dB for implementation in a digital stethoscope. Sketch the circuit diagram and show all calculations for your design.

Step by Step Solution

★★★★★

3.42 Rating (161 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

We know that Vout 20 logio Vin Gain in dB z so Vou... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Design an active low pass filter with cutoff frequency 1 kHz, |Vo/Vin at frequency 1.5 KHZ = 5, and when the input is 3 cos wt Volt, the power dissipated in the source resistance ( R ) of the filter...

Sketch the circuit diagram of a quasi-complementary amplifier, showing voltage waveforms in the circuit.

Design a low-pass filter with a cutoff frequency between 15 and 16 kHz.

Design an active-RC low-pass second order Chebyshev filter with a cutoff frequency of 1 kHz, a passband gain of 2 V/V and approximately 2 dB of ripple. If using Table I, use a capacitor value of 0.1...

Don't use chatgpt otherwise I'll down vote so please provide genuine answer.. 7. Design a single order active high pass filter for a cutoff frequency at 8500Hz and with a pass band gain of 25dB. Use...

An engineer is measuring an unsteady voltage with a DAQ. The signal of interest is typically below 10 Hz, so they sample at 25 Hz to avoid aliasing. They want to construct a passive first-order low-...

How many turns should a coil of an inductor be needed in a low pass filter with a cut-off frequency of 200 Hz when the load has a resistance of 8 ? Considering the inductor was air-cored ( r=1H/m)...

Design Evaluation A need exists for a third-order Butterworth low-pass filter with a cutoff frequency of 2 krad and a dc gain of 0 dB. The design department has proposed the circuit in Figure P1459....

128 Design a low-pass filter with a cutoff frequency of 2 krad=s and a passband gain of 1. Validate your design using Multisim.

Kool-Aid borrowed $60,000 on November 1, 2015 by signing a $61,350, 3-month zero-interest-bearing note. Prepare Kool-Aids November 1 st entry, December 31 st entry to record interest, and repayment...

Solve and indicate whether the following series are convergent or divergent Ans: Diverges by Limit Comparison Test 0 3 m=1 7" n! Ans: Converges by Integral Test 8 h= n=1 Thus, this diverges by the...

A farmer installed a tank for the purpose of keeping the hot water for his residential house in the farm. The tank is made of mild steel of wall thickness 10 mm and contains water at 90oC. Calculate...

Explain why you chose the specific article? How is it relevant to the current health care landscape? Discuss current event from the perspective of a health care administrator. Document your thoughts...

7. A series of transactions for Ace Repair is given below. Use the chart to show the effect of each of the transactions on assets, liabilities, and owner's equity by placing an x in the appropriate...

(CLO3) Sam and Mike are discussing using a new project management framework. Mike mentions that no matter what the team should always be willing to try new things. Sam asks Mike to focus on the pros,...

5..r ritidin' on ara i:10 |strin. | carete tinit nertean: tedevite : = :T iT :-L, Dweat ad .HA* 'helvs:Oy w* W.L, lub_ind tirlilit!,20; it itl-. beritide tilas? 12 In-t+1ntiace TFX 1 IASD: KET N.I1,...

suppose a nickel-contaminated soil 15 cm deep contained 800 mg/kg Ni, Vegetation was planted to remove the nickel by phytoremediation. The above-ground plant parts average 1% Ni on a dry-weight bas...

The voltage generated in one phase of an unloaded three-phase synchronous generator is of the form v(t) = Vo cos cot. Write expressions for the voltage in the remaining two phases.

Using the magnetization characteristics for samarium cobalt given in figure, find the point of maximum energy product and the corresponding flux density and magnetic field intensity. Using these...

A 75-kW, 460-V, three-phase, four-pole, 60-Hz, wound-rotor induction motor develops a maximum internal torque of 212 percent at a slip of 16.5 percent when operated at rated voltage and frequency...

The article Uncertainty Estimation in Railway Track LifeCycle Cost (J. of Rail and Rapid Transit, 2009) presented the following data on time to repair (min) a rail break in the high rail on a curved...

Show that for any , when the population distribution is normal and s is known, the two-tailed test satisfies , so that is symmetric about m0.

For the following pairs of assertions, indicate which do not comply with our rules for setting up hypotheses and why (the subscripts 1 and 2 differentiate between quantities for two different...