Question: A horizontal 2 0 cm diameter water pipe has in it a venturi meter of throat diameter 1 2 . 5 cm , which is

A horizontal 20 cm diameter water pipe has in it a venturimeter of throat diameter 12.5cm, which is connected to a mercury manometer showing a head difference of 87.8 cm. Find the velocity in the throat and the discharge. State all assumptions made.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

Water of density 1 0 0 0 kg / m 3 flows along a horizontal pipeline of 2 x mm ( where X is equal to last digit of your student number ) diameter at an unknown rate ( Figure Q 8 a ) . A Venturi meter...

Q:

Question 9 . 9 . 1 A 1 0 mm diameter sharp - edged orifice is provided in the vertical side of a water tank. The centre line of the orifice is 7 5 0 mm below the water level. The set of water issuing...

Q:

need help fast please A pump takes water at 70F from a large reservoir and delivers it to the bottom of an elevated pressurized tank (P= 15 psig) through a 2.5-in Schedule 40 pipe. The inlet to the...

Q:

Please answer as soon as possible A pump takes water at 70F from a large reservoir and delivers it to the bottom of an elevated pressurized tank ( P= 15 psig) through a 2.5-in Schedule 40 pipe. The...

Q:

Water flows at 0.07 cubic meter per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to measure the velocity inside the pipe. Based on manometer reading, the...

Q:

a) A slurry having 30% solid by mass of an ore (SG of clay = 3.0) made up with water behaves as a Newtonian non-settling slurry and is pumped through a horizontal 6 cm diameter smooth pipe, at an...

Q:

2. a) A fluid of a density equal to 960 kg/m is flowing steadily through the horizontal tube shown Figure 2.1 below. The diameter at section 1 is 100 mm and at section 2 is 80 mm. Also the gauge...

Q:

( a ) Describe the operating principle of a Venturi meter. For full marks, draw a schematic diagram of the device and indicate all the important variables. ( b ) A horizontal Venturi meter with a...

Q:

QUESTION FOUR A Venturi meter is used for measuring flow of water along a pipe. The diameter of the Venturi throat is two fifths the diameter of the pipe. The inlet and throat are connected by water...

Q:

a A horizontal US schedule 40 pipe has the Nominal Diameter of 5 inches. Gasoline fuel is flowing inside the pipe with a volumetric flowrate of 124.6 gallons/min. A Venturi meter is fixed in the pipe...

Q:

It can be proved that, other things being equal, under price discrimination the price charged to some customer group will be higher the less elastic the demand curve of that group is. Why is that...

Q:

Flow between two tanks (Fig. 7B.4). Case I: A fluid flows between two tanks A and B because PA > PB. The tanks are at the same elevation and there is no pump in the line. The connecting line has a...

Q:

One of the most important components of stock evaluation is a firm's estimated growth rate

Q:

On September 5th, Fast Forward Inc. provides a cleaning service to their customer on credit. The value of the cleaning service is $200. Which of the following journal entries does Fast Forward Inc....