Question: ( a ) How do you model the power transmission lines? ( b ) Consider a short transmission line with an impedance of ( 1

(a) How do you model the power transmission lines?
(b) Consider a short transmission line with an impedance of (1.0+j10.0) ohm, and the load at the receiving end is S=(50+j10)MVA and the voltage at the receiving end 35 kV . Find the sending end voltage and power, and transmission efficiency.
( a ) How do you model the power transmission

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Phase of a three-phase, 60 Hz, 300 km long power transmission line with a nominal operating line voltage of 500 kV. its inductance per 291 mH / phase, and its capacitance is 3.45uF/phase. Voltage...

Q:

A quarter-wavelength transmission line is typically used for narrow-band impedance matching between two transmission lines or between a transmission line and real impedance. This matching technique...

Q:

Problem 3. Consider the following network. Nodes A to H are power stations connected together using power transmission lines. a) Assume the numbers on the graph show the maximum power flow capacity...

Q:

(a) Consider complex power transmission via the three-phase short line for which the per-phase circuit is shown in Figure 5.19. Express \(S_{12}\), the complex power sent by bus 1 (or \(V_{1}\) ),...

Q:

Hello, can you assist me with the following law question? Lets assume that Bill Dell Aluminum, acquired the stock and assets of the NY Cable Corporation and that the United States brings suit...

Q:

chapter 29 pt 2 29.9 9. | Although the evidence is weak, there has been concern in re- BIU cent years over possible health effects from the magnetic fields generated by electric transmission lines. A...

Q:

EXPERIMENTAL SECTION L- G Fault Analysis 1.1 EXPERLMENTAL OBJECTIVE To analyze and calculate different fault currents that occur due to the introduction of faults (L-G. ) in transmission line using...

Q:

Question 1: Transmission Lines [25 marks] Hint for Q1.1-21.3: Power dividers, or power splitters, are used to split an input signal into two output signals, or combine two signals into one in the...

Q:

Once the stepped leader has made contact with the earth it is believed that a power return stroke(Fig. 1.6(c)) moves very fast up towards the cloud through the already ionized path by the leader....

Q:

With a particular number of towers the chances of incidence of lightning on power conductor scan be minimized by placing a ground wire at the top of the tower structure.. The tower presents a...

Q:

Select at least three Enterprise Resource Management (ERM) programs, such as SAP. Provide an overview of each of the ERM program Compare and contrast the three programs highlighting similarities and...

Q:

Given the information in Exercise 13.20, use the 0.05 level in testing whether the number of defectives in each batch of n = 25 could be binomially distributed with Ï = 0.1. In exercise x Number...

Q:

Assume the British pound is worth $ 1 . 6 0 , and the Canadian dollar is worth $ . 8 0 . What is the value of the Canadian dollar in pounds? 2 0 0 cdots 8 0 * * None of these are corred.

Q:

What is the research question in the paper: A framework for approaching mixed methods intervention research to address the emotional and behavioral health needs of children. By: Houchins, David E.,...