A most: with a single veica] slit is placed between a laser and a screen as shown in the top-view diagram below right. The photograph above the diagram shows the resulting pattern on the screen. H is the distance between the tlatir. spots on either side of the center of the pattern. measured by placing a ruler against the screen. {See the photograph.) . Is the slit width greater than. less than. or equal to it, the wavelength til the laser light\"? Elplain puns reasoning. Single vertical slit in center of mast: {not strewn} \\\\ Patient on screen Top-view diagram Laser (aimed at slit in mask] In the following questions. consider how a single change to the original apparatus would affect the distance H {described sleeve). a. If the right half of the slit were covered [so that no light could pass though that side}. would the distance H increase. decrease. or stay tire mate? Explain. la. The pattern at the top oi the page was produced by a laser that emits reel light. If the laser were replaced by a laser that emits green light {l.e.. light with a sherter wavelength}, would the distance H increase, decrease. or stop tire same? {The slits are both uncovered.) Explain. c. If the screen were moved further from the dit (using the original taser), would the distance H increase, decrease, or say the same as in the original situation? Explain. d. If the intensity of the (original) laser were increased, would the distance H increase. decrease, or way the name is in the original truction? Explain