Question: A PCM system uses a uniform quantizer followed by a 7 - bit binary encoder. The bit rate of the system is equal to 5

A PCM system uses a uniform quantizer followed by a

7 -

bit binary encoder. The bit rate of the system is equal to

50

106

/

.

What is the maximum message bandwidth for which the system operates satisfactorily? Determine the output Signal to Quantization noise ratio when a full load sinusoidal modulating wave of frequency

1

MHz is applied to Input

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

A PCM system uses a uniform quantizer followed by a 7-bit binary encoder. The hit rate of the system is equal to 50 x 106b/s (a) What is the maximum message bandwidth for which the system operates...

6 . 1 1 A PCM system uses a uniform quantizer followed by a 7 - bit binary encoder. The bit rate of the system is equal to 5 0 1 0 6 bits / s . a . What is the maximum message bandwidth for which the...

An analogue signal of frequency 5 MHz in Figure is applied to the input ors poise code modulation (PCM) system. The PCM system samples the signal at a rate 75% above the Nyquist rate and employs a...

hi i need answer in 2 hours please my roll no is 26 please answer it asap.... Question 3: (CLO3-PL04-C6, 25 marks) You are entrusted to develop Analog to Digital conversion system for audio signals...

Read the above passage and then answer short questions Summarize and elaborate the research method of this article in concise language Application Research Based on Machine Learning in Network...

Consider the pulse code modulation (PCM) system described below: The message signal with a bandwidth of 5 kHz is sampled at a rate 20% above the Nyquist sampling rate. This signal is then passed...

n L - level uniform quantizer is used for audio quantization, where L is an even number. The peak - to - peak value Vpp = 2 Vp is equal to Lq , in which Vp is the peak value and q is the step size or...

Read the above passage and then answer short questionsplease use 1,2,3,4 to write a simple and clear overview of the steps for the research process of this article, a hand-drawn chart is better....

Read the above passage and then answer short questionsWhat can be improved about the research method of this paper, that is, where is the gap? Application Research Based on Machine Learning in...

Read the above passage and then answer short questionsThe research method of this paper can be further upgraded and changed. Could you give a general explanation? Application Research Based on...

For what value of K., the system shown in the figure having G(s) = and forward path controller as (G-1) G.= KKWill have closed loop poles at s=-0.5 and s=-1 2.5 none of the mentioned O0.75 O 0.5

The figure shows the state of stress at a point. Knowing that the maximum in-plane shear stress at this point is 10 MPa, determine the value of y.

Financial position at a point in time matches with what prompt? The answer prompt's options are Balance Sheet, Change in Retained Earnings, Asset Exchange Transaction, Stockholders' Equity, GAAP,...

The v ? s graph for a test vehicle is shown. Determine its acceleration when s = 100 m Determine its acceleration when s = 160 m 50 50 v (m/s) 150 200 s (m)