Question: A shaft will serve as a mating surface for a full - compliment set of 3 2 needle rollers. If the rollers will have a

A shaft will serve as a mating surface for a full-compliment set of 32 needle rollers. If the rollers will
have a diameter of 8 mm, what diameter should be ground into the shaft? If the bearings will support
a load of 8 kN, what is the maximum force exerted on a roller? Assume the diametral clearance is
zero. Ans. d =81.49 mm,(wz)max =1000 N

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

Summarizes the lessons which you learned from case PRIMATERIA AB: SCALING UP AND PROTECTING IP about innovation and engineering consulting, operations and/or supply chain management consulting, the...

Q:

(Please read the question carefully before you answer) Tenalpina is adding a new product line, which will add some a new costs as well. Based on Giulia's estimates and assuming that the volumes for...

Q:

The Charpy impact test is a dynamic test in which a specimen is struck and broken by a pendulum (or hammer) and the energy absorbed in breaking the specimen is measured. The energy values serve as a...

Q:

The judge held to carry out a new trial for the case below. You are the lawyer for the defendant . In the position of the defendant (Baxendale and Ors), under the issue of remoteness of damage ,...

Q:

North Platt Machinery Company manufactures a shaft that must fit inside a sleeve. The firm has just received an order of 41,000 units from Southernstar Exploration Company for $40 per unit. North...

Q:

Problem: The driving shaft shown in Figure (2) is used to transmit the power from the motor (which is connected to pulley A via a flat belt) to the gear at B (which is meshed with the driving spur...

Q:

Please answer the whole question. Answer whole questions are necessary. Part B It is proposed to introduce a surge shaft to protect supply tunnel from pressure rise that propagates towards the supply...

Q:

Analytics Exercise 21-3 (Algo) Recently, Phil Harris, the production control manager at Brunswick, read an article on time-phased requirements planning. He was curious about how this technique might...

Q:

North Platt Machinery Company manufactures a shaft that must fit inside a sleeve. The firm has just received an order of 52,000 units from Southernstar Exploration Company for $44 per unit. North...

Q:

No coding provided but needed help with this one Exercise 2 - Simple Animation (6 points) If you do not complete this exercise during the lab period, you need to complete the work outside of the lab...

Q:

CRS Products Inc. uses a job order cost system. Selected transactions dealing with factory items for the month follow: a. Requisitioned indirect materials from storeroom, $3,200. b. Purchased, on...

Q:

Use the sustainability product portfolio of the company that you established in Exercise C.8 to describe concrete impact improvement proposals for the three most unsustainable products. Provide a...

Q:

Explain the conditions under which Sec. 7 5 1 has an impact on nonliquidating ( current ) distributions.

Q:

En 2018, la profesora Patricia (Patty) Pt se retir de laAcademia de Artes Culinarias de Palm Springs (PSCAA). Escontribuyente soltera y tiene 62 aos. Patty vive en 98 ColanderStreet, aparta 0 answers