Question: A single phase 2 3 0 V , 1 KW heater is connected across single phase 2 3 0 V , 5 0 Hz supply

A single phase 230V,1 KW heater is connected across single phase 230V,50Hz supply through a diode. Calculate the power delivered to the heater element. Find also the peak diode current and input power factor

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

What is "profiling"? What are the advantages and disadvantages of its use? How does the use of profiling relate to ethics? 20) A moral and ethical issue raised by the information age is the...

Q:

What is "profiling"? What are the advantages and disadvantages of its use? How does the use of profiling relate to ethics? 20) A moral and ethical issue raised by the information age is the...

Q:

Miller-Rabin test to check whether a number N is composite. This will involve computing a N1 mod N for some value of a. [10 marks] Carry out the steps for N = 65 and a = 1, 2, 8 and 12. on what each...

Q:

write a business analytics report addressing the following questions. 1. What key factors should Summers consider when deciding about optimizing EVT's network of DCs? [10%] 2. What is the total...

Q:

1.Sketch a line diagram to the types of business organisation on the basis of ownership 2.What do you understand by joint sector companies? Mention the diagrams for the formation of joint sector...

Q:

1.Sketch a line diagram to the types of business organisation on the basis of ownership 2.What do you understand by joint sector companies? Mention the diagrams for the formation of joint sector...

Q:

(Question 1) A periodic voltage waveform observed on an oscilloscope across a load is shown. A permanent magnet moving coil (PMMC) meter connected across the same load reads (Question 2) With initial...

Q:

1. Using stress-strain diagrams, show the difference in deformation response between elastic and linear viscous (newtonian) materials. Label your diagrams 31. List three types of material objects...

Q:

A single phase 230 v 1 kw heater is connected across single phase 230 v , 40 Hz supply through a diode . Calculate the power delivered to the heater element find Peak diode current

Q:

Question 1: The flux per pole in a synchronous motor with the field circuit ON and the startor disconnected from the supply is found to be 25 mWb. When startor is connected to the rated supply with...

Q:

What is the effective interest rate corresponding to a nominal annual rate of: a. 4% compounded monthly? b. 8%compoundedmonthly? c. 12% compounded monthly?

Q:

Lana, a ten-year-old child, is run over by a car negligently driven by Mitchel. Lana, at the time of the accident, was acting reasonably and without negligence. Clark, a newspaper reporter,...

Q:

Certer manufacturing uses standard costing and has established the following direct material and direct labor standards for each unit of the single product it produces: Question: Carter Manufacturing...

Q:

Which one of the following is NOT correct? ( A ) Intermediate principal stress is ignored when applying the maximum principal stress theory ( B ) The maximum shear stress theory gives the most...