Question: A single - phase transformer has 5 0 0 turns on the primary and 5 0 turns on the secondary winding. The primary is connected

A single-phase transformer has 500 turns on the primary and 50 turns on the secondary winding. The primary is connected to 3000 V,50 Hz suply and load current is 100 A
a- Write the assumptions made for the ideal transformer (10 p)
b- Find the full-load voltage and full loadpower,(10p)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Calculate the transformer losses when the resistor connected for all six cases (10V, 20V, 30V, 40V, 50V, and 60V). Explain any discrepancies between input power and output power. List the sources of...

Q:

Q.23- A 200 KVA, 66000/400 V, 50 HZ, single phase transformer has 80 turns on the secondary side and cross sectional area of the core is 80 sq.cm. Neglecting losses, calculate: (i) The full load...

Q:

(Question 1) A periodic voltage waveform observed on an oscilloscope across a load is shown. A permanent magnet moving coil (PMMC) meter connected across the same load reads (Question 2) With initial...

Q:

Q.17- Write the construction and working principle of single phase transformer. Q.18- Derive the EMF equation of a single phase transformer. Q.19- Differentiate between the core type and shell type...

Q:

- 5. A 5 kVA, 1 transformer has a core loss of 40 W and full load ohmic losses of 100 W. The daily variation of load on the transformer is as follows 7 am to 1 pm 3 kW at 0.6 p.f. 1 pm to 6 pm 2 kW...

Q:

High-frequency transformer (HFT) operates using the same principles as standard transformers. The main difference is that, as its name implies, it operates at higher frequencies, whereas most power...

Q:

A transformer has 1000 turns of wire in its primary coil and 2000 turns of wire in its secondary coil. A sinusoidal 30 VRMS Voltage source is attached to the primary coil and a load resistor of 100 2...

Q:

Whenever a lab asks you to assemble a circuit, and measure some quantities, implement (capture) the circuit in MultiSim, and use its simulation tools to gather the measurements. Rectification is the...

Q:

1. A transformer having 1000 primary turns is connected to a 250 V ac supply. For a secondary voltage of 400 V, the number of secondary turns should be : 2. A 3 phase step down transformer is...

Q:

EEE4115 Electrical Engineering principle Assignment 1 Q1 A IKVA ideal single phase step-up transformer is supplied by a 24 V ac power source and is delivering power to a 10 resistive load connected...

Q:

A 250-L rigid tank contains methane gas at 500C, 600 kPa. The tank is cooled to 300 K. a. Find the final pressure and the heat transfer for the process. b. What is the percent error in the...

Q:

What is earnings management and how does it relate to agency theory? What motivation do senior managers have for engaging in earnings management? Undertake some brief research and provide evidence.

Q:

ssume there are no tax credits, and we are evaluating the taxes faced by a single taxpayer filing in 2 0 2 4 . Under the California income tax, an individual with $ 1 0 0 , 0 0 0 in total taxable...

Q:

Required information [The following information applies to the questions displayed below] Laker Company reported the following January purchases and sales data for its only product. The Company uses...