Question: A Wilkinson power divider will be designed, see figure below. It will be implemented on a Rogers RO 4 3 5 0 B substrate, with

A Wilkinson power divider will be designed, see figure below. It will be implemented on a Rogers RO4350B substrate, with a thickness of 0.254 mm , using transmission lines in a 500 hm system. What is the width and the length of the two branches at 2450 MHz ? Use the supplied datasheet for more information if needed.
A Wilkinson power divider will be designed, see

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Consider a Wilkinson power divider with the common node labeled as Port 1 and the two other nodes labeled as Ports 2 and 3. a)Show that if a 2 =a 3 , then b 2 =b 3 =0, and, and no power is dissipated...

Q:

please solve this question quickly its a request Question 1: a) Design a cascaded 1x4 Wilkinson Power Divider with the power division ratio of 1:2:3:5. Also ensure that the output ports are...

Q:

Question 1: Transmission Lines [25 marks] Hint for Q1.1-21.3: Power dividers, or power splitters, are used to split an input signal into two output signals, or combine two signals into one in the...

Q:

For the power divider below, and without using a calculator, determine what is the power P in watts and dBm if P = {0, 13} dBm and a = {0.25, 0.5) (four total inputs). Show your work converting dBm...

Q:

(0) Delay-lock discriminator Power divider (-9+7) 0,(r) Spreading waveform generator 3(2) a (1) EF band pass 2,01) filter BN IF bandpass filter BN Power divider c(-P-4.T.) Local oscillator Lowpass...

Q:

Repeat Prob. 2.75 for the eight-way divider shown in Fig. 2.136 . Prob 2.75 Find R ab in the four-way power divider circuit in Fig. 2.135. Assume each R = 4 Ω. inIim LinLw Lui bo ww- ww-...

Q:

The output impedance of a power divider in a microwave network is measured to be 50 ohms, and the impedance of the next stage is 30 ohms. This level of mismatch can result in significant errors in...

Q:

2. As shown in the figure below a turn-style antenna consists of two dipole antennas fed 90 out of phase with each other and are oriented perpendicular to each other in the same plane. (a) Show that...

Q:

Find Zab in the four way power divider circuit in Fig. 2.135. Assume each element is 1(. Figure 2.135 For Prob. 2.75. bo

Q:

The data set below contains the overall miles per gallon (MPG) of 20 small SUVS from one year. Complete parts (a) and (b). 27 26 25 23 22 21 22 21 20 20 20 21 22 22 22 D 21 20 20 20 21 a. Decide...

Q:

Question 1: Prepare a liquidity (cash flow) budget for December for lron and Steel A/S. Question 2: Then prepare an operating budget for December for lron and Steel A/S. (Please disregard other...

Q:

QUESTION 1 A company that manufactures jeans incurred the following expenses during the year ended 3 1 March 2 0 1 8 : Raw material purchases Direct wages paid ? 7 Supervisors' wages? Wage payroll...

Q:

please help paid an annual dividend of \( \$ 1.47 \) a share last month. The company is planning on paying \( \$ 1.52 \), \( \$ 1.8 \), and \( \$ 1.90 \) a share over the next three years,...