V =10v How will it look like in Orcad with Bias voltage and Bias Current displayed? Delta

V =10v

How will it look like in Orcad with Bias voltage and Bias Current displayed?

Transcribed Image Text:

Delta to Wye Conversion R, R2 R. Rs Figure 2-6: Circuit Diagram 1) Start OrCAD [Appendix A-1] 2) Add a Resistor [Appendix A-2] R-5.IKO, Ra-I KO, R- Ry-2 KO, R- Re-3.9 KO 3) Add DC Voltage Source (Vdc) between the two nodes A and B- ask your engineer Volt[Appendix A-5] 4) Add Ground [Appendix A-11] 5) Connect the circuit by adding wires [Appendix A-10] Activate Windo Go to ttings to c 6) Select the bias point simulation analysis [Appendix A-15] 7) Simulate the circuit [Appendix A-13] Delta to Wye Conversion R, R2 R. Rs Figure 2-6: Circuit Diagram 1) Start OrCAD [Appendix A-1] 2) Add a Resistor [Appendix A-2] R-5.IKO, Ra-I KO, R- Ry-2 KO, R- Re-3.9 KO 3) Add DC Voltage Source (Vdc) between the two nodes A and B- ask your engineer Volt[Appendix A-5] 4) Add Ground [Appendix A-11] 5) Connect the circuit by adding wires [Appendix A-10] Activate Windo Go to ttings to c 6) Select the bias point simulation analysis [Appendix A-15] 7) Simulate the circuit [Appendix A-13]