Question: An effective ground - fault current path must have which of the following characteristics? a . Be of low impedance b . Have sufficient current

An effective ground-fault current path must have which of the following characteristics?
a. Be of low impedance
b. Have sufficient current-carrying capacity
c. Must facilitate the operation of overcurrent protective devices or the operation of ground detectors in high-impedance grounded neutral systems
q, d. All of the above
An effective ground - fault current path must

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Once the stepped leader has made contact with the earth it is believed that a power return stroke(Fig. 1.6(c)) moves very fast up towards the cloud through the already ionized path by the leader....

Q:

With a particular number of towers the chances of incidence of lightning on power conductor scan be minimized by placing a ground wire at the top of the tower structure.. The tower presents a...

Q:

This streamer is very intense where the current varies between 1000 amps and 200,000 amps and the speed is about 10% that of light. With a particular number of towers the chances of incidence of...

Q:

We know that the voltage and current transmitted into the tower will depend upon the surge impedance of the tower and the ground impedance (tower footing resistance) of the tower. If it is low, the...

Q:

The tower presents a discontinuity to the travelling waves; therefore they suffer reflections and refraction. The system is, then, equivalent to line bifurcated at the a towerpoint.We know that the...

Q:

The system is, then, equivalent to line bifurcated at the a towerpoint.We know that the voltage and current transmitted into the tower will depend upon the surge impedance of the tower and the ground...

Q:

If it is low, the wave reflected back up the tower will largely remove the potential existing due to the incident wave. In this way the chance of flashover is eliminated. If, on the other hand, the...

Q:

It is, therefore, desired that for good line design high surge impedances in the ground wire circuits, the tower structures and the tower footing should be avoided. High saturation induction (to...

Q:

The sensitivity of a relay refers to the smallest value of the actuating quantity at which the relay operates detecting any abnormal condition. In case of an over current relay, mathematically this...

Q:

In case of an over current relay, mathematically this can be defined as the ratio between the short circuit fault current (Is) and The relay operating current (Io). The value of Io should not be too...

Q:

Microlenders are institutions that lend relatively small amounts of money to businesses. An article on microlenders compared the average return on equity for lenders of two categories based on their...

Q:

Watson group has two production departments (Assembly and Finishing) and one service department (First Aid). The following analysis of overhead costs has been made for the year just ended. Assembly...

Q:

Victory ( Pty ) Ltd ( Victory ) manufactures affordable financial calculators in Polokwane. Victory has a 3 1 March year - end. Below is a summary of management accounts for the year ended 3 1 March...

Q:

. Power Corporation owns T5 percent of Surge Company's stock: no lntercompangir purchases or sales were made in 20x4. For the year. Power and Surge reported sales of $380,000 and 3230.000 and cost...