Question: Analyse the beam loaded as shown in Figure. 7 , by the slope - deflection method if the support ' C ' sinks by 2

Analyse the beam loaded as shown in Figure. 7, by the slope-deflection method if the support 'C' sinks by 20mm. And draw the bending moment diagram.
Analyse the beam loaded as shown in Figure. 7 ,

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

XYZ is a calendar-year corporation that began business on January 1, 2018. For the year, it reported the following information in its current-year audited income statement. Notes with important tax...

Q:

Problem 3 : Deflection Calculation ( Virtual work method ) Determine slope at A and vertical deflection at point D of the beam loaded as shown in Figure 3 below using virtual work method. The cross...

Q:

Statically indeterminate beam analysis. Calculate the BMs ( bending moments ) at all the joints of the beam shown in Fig. 1 using the slope deflection method. The beam of span L m is subjected to an...

Q:

Determine the slope and deflection at a point 1 m from the left hand side of the beam loaded as shown in figure below, using double integration method. E I = 0 . 6 5 MPa.

Q:

Question 2 Figure shows a two - span continuous beam with uniform section. The support B sinks by 1 0 mm below B and the support C sinks a further 2 0 mm below B . Analyse the beam by the slope...

Q:

The simply - supported beam ABC is loaded as shown in Figure Q 3 . Support A is a pin, and Support C is a roller. A uniformly distributed load of 5 0 k N m is applied in the segment of both A B and B...

Q:

Q 1 . Using the Moment - Area Method, calculate the slope at A and the deflection at mid - span of the loaded simply - supported beam below. Assume EI is constant. Q 2 . For the cantilever beam...

Q:

QUESTION 1 A simply supported beam of length L is loaded at mid-span with a concentrated load, P. For this beam, the following equation is obtained from the Macaulay's Method. EX - ( =12 ) - ( = )( x...

Q:

helpQUESTION 2 A frame with a fixed and a pin support is shown in Figure 2 . The flexural stiffness of the column " AB " is equal to 3 E I and for the beam " BC " is equal to EI . The column is...

Q:

Deflection Calculation using virtual work method. Determine slope at A and vertical deflection at point D of the beam loaded as shown in the figure below using virtual work method. The cross section...

Q:

Note: Assume the suitable data if any. 1 . Determine the support reactions of the fixed beam shown in Figure 1 . Neglect horizontal reactions. OR ( 1 4 Marks ) ( 1 ) Determine the force in various...

Q:

The classification of the specific type of fraud that is alleged is important to ensure that the correct investigation and data collection methods are used. The fraud tree is a framework that is used...

Q:

In your opinion, should the possible adoption of fresh start accounting be open to any corporation where management feels traditional historical cost-based accounting no longer allows them to present...

Q:

Match the terms below with the characteristic they are most likely to have. legend folltale divine myth fables

Q:

Which of the following is a disadvantage of a "rules-based" approach to standard- setting? Select one: O a. The body of knowledge is significantly larger than in a "principles-based" system. O b....