Question: Answer Range: 2.85 - 3.0 In a waterjet machining process, the water pressure used is 500MPa. The diameter of orifice of the nozzle through which

Answer Range: 2.85 - 3.0
In a waterjet machining process, the water pressure used is 500MPa. The diameter of orifice of the nozzle through which the waterjet comes out is 0.25mm. Neglecting frictional and other losses, and using the density of water as 1000kg/m3, the mass flow rate of the waterjet (rounded off to two decimal places) in kg/min is
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
