Apply a $0\mathrm{.}15$ straightness line element control to the surface of the part above and show the resultant tolerance zone on the produced part below.

Can the MMC or LMC modifier be applied to this control? Why or Why not?

Apply a dia $0\mathrm{.}5$ at MMC straightness control to the axis of the part above and draw the resultant tolerance zone and virtual size on the sketch of the produced part below.

Complete the chart illustrating the effect of the MMC modifier applied to the straightness tolerance.

$\backslash$table$[[$Feature Size,Tol Zone Size,Virtual$],[\frac{O}{13\mathrm{.}5},\frac{O}{?},],[\frac{O}{13\mathrm{.}4},\frac{O}{?},],[13\mathrm{.}3,\frac{O}{?},\frac{O}{?}$