As an engineer, you will be tasked with designing a hoist gear system that can lift a 50kg product (output 1), grinder with the output torque 500Nm (output 2), and a 25kg product (output 3). The gear train system should have one input and three outputs, with three gear meshes between each input and output. Only the compound gearsets must be included in the system. To complete this task, you should use software such as Solidworks or AutoCAD to sketch the gear hoist system. Additionally, you should show a sample of manual calculation to obtain the overall efficiency based on your design. Your design should achieve more than 65% overall efficiency. Finally, you should iterate the angular acceleration at the input from 1.2 rad/s to 10 rad/s in Increments of 0.2, plot the graph of the overall efficiency against the angular acceleration at the input using Matlab, Python, or Octave. Design the gear hoist system using solidworks, autocad etc. Analyse your findings and discuss the result obtained. Given: Equivalent mass moment of inertia, I for all shat in the system is 5 kgm Friction torque in bearing, F for all bearings in the system is 10 Nm All gear mesh efficiency is, n = 80% Radius for drums at the output should be 0.5 m and 0.5 m. Angular acceleration at the input is 1.2 rad/s 253 25 N 20 2015 21: in A