Question: A 60 cm-long, 3 cm-diameter AISI 1010 steel rod with thermal conductivity of 59 W/m-K is welded to a furnace wall and passes through 20

A 60 cm-long, 3 cm-diameter AISI 1010 steel rod with thermal conductivity of 59 W/m-K is welded to a furnace wall and passes through 20 cm of insulation before emerging into the surrounding air. The furnace wall is at 300^o C?, and the air temperature is 20^o Cn? Estimate

a). the heat loss through the rod, and

b). the temperature of the bar tip if the heat transfer coefficient between the rod and air is taken to be 13 W/m² K.

20 cm 3 cm diameter Insulation AISI 1010 steel rod Furnace wall

20 cm 3 cm diameter Insulation AISI 1010 steel rod Furnace wall 60 cm Air

Step by Step Solution

★★★★★

3.54 Rating (168 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

A sheet of insulating material, with thermal conductivity of 0.22 W/m K, is 2 cm thick and has a surface area of 2.97 m 2 . If 4 kW of heat are conducted through this sheet and the outer (cooler)...

A long steel rod (2 cm in diameter, 2 m long) has been heat-treated and quenched to a temperature of 100C in an oil bath. In order to cool the rod further it is necessary to remove it from the bath...

A plane wall 15 cm thick has a thermal conductivity given by the relationk = 2.0 + 0.0005 T W/(m K)where T is in degrees Kelvin. If one surface of this wall is maintained at 150 ?C and the other at...

A copper sphere 2.5 cm in diameter is suspended by a fine wire in the center of an experimental hollow cylindrical furnace whose inside wall is maintained uniformly at 430?C. Dry air at a temperature...

A stainless steel pin fin 5 cm long, 6 mm OD, extends from a flat plate into a 175 m/s air stream as shown in the accompanying sketch.(a) Estimate the average heat transfer coefficient between air...

Repeat Problem 7.13 with glycerol at 20?C flowing over the fin at 2 m/s. The plate temperature is 50?C. From Problem 7.13: A stainless steel pin fin 5 cm long, 6-mm-OD, extends from a flat plate into...

A mercury-in-glass thermometer at 40C (OD = 1 cm) is inserted through a duct wall into a 3 m/s airstream at 66C. This can be modelled as a cylinder in cross-flow, as shown in the figure. Estimate the...

A sphere (k = 185 W/m K, = 7.25 x 105 m2/s) of 30-mm diameter whose surface is diffuse and gray with an emissivity of 0.8 is placed in a large oven whose walls are of uniform temperature at 600 K....

A manned spacecraft capsule has a shape of a cylinder 2.5 m in diameter and 9 m long. The air inside the capsule is maintained at 20?C and the convection-heat-transfer coefficient on the interior...

A long wooden rod at 38?C with a 2.5 cm diameter is placed into an airstream at 600?C. The heat transfer coefficient between the rod and air is 28.4 W/(m2 K). If the ignition temperature of the wood...

A little more than 10 months ago, Luke Weaver, a mortgage banker in Phoenix, bought 300 shares of stock at $40 per share. Since then, the price of the stock has risen to $75 per share. It is now near...

given maps. In the following questions, find the image of the set D under the (a) D={z Rez0, Im z = (0, )}, f(z) = e. (b) D= {2: Arg(2) = (0,3)}, f(z) = e. (Hint: think of e as the composition of two...

Orange Company purchased equipment in January of 2 0 1 1 for $ 4 0 0 , 0 0 0 . The equipment was being depreciated on the straight - line method over an estimated useful life of 2 0 years, with no...

A new employee has been given responsibility for preparing the consolidated financial statements of Sample Company. After attempting to work alone for some time, the employee seeks assistance in...

Alex is a carpenter who purchased a vacant block of land in Sydney on 1 October 1980. On 1 September 1986, Alex built a house on the land. At the time, the land was valued at $110,000 and the cost of...

Assume there is a well-defined geographic area of a city. The area is composed exclusively of apartments and is populated by low-income residents. The people who live in the area tend to stay in that...

The average collection period is computed by dividing a. net credit sales by ending gross accounts receivable. b. 365 days by the accounts receivable turnover ratio. c. net credit sales by average...

Refer to the MANAGEMENT AT WORK case study in your book (Chapter 8, pp. 222-223) titled " Elementary, Watson" . 1. These days, according to more and more experts, every worker is a knowledge worker....

Provide a well-written essay of approximately 200 words.Once again, you have some latitude in your approach.Describe how Reagan and Thatcher were philosophically and economically aligned. How would...

I need to make a summary report and total cost per job using the numbers provided. watu 10018 Add-ons Help Last edit was 2 days ago % 0,09 123- Default (Ca... - 11 BISA 100% ES A B C D E G H 1 2 3 4...

Mark GradeID 88 82 55 56 72 87 55 82 73 77 91 86 44 62 94 87 72 80 89 92 83 81 78 44 58 41 84 47 73 82 97 47 46 42 43 41 62 81 38 70 49 79 57 73 77 55 48 94 Topic raisedhandVisITedRes Announcem...

Please use the information shown above. Perform a format with the A3 methodology A garment manufacturing firm specializing in the production of technological business uniforms made of unique fabrics...

Please, with the information shown below, make a format with the Objectives Planning Methodology (OGSM). A garment manufacturing firm specializing in the production of technological business uniforms...

Please use the information below to answer the following questions: These questions are based on the A-3 methodology 1. BACKGROUND : Why are we talking about this problem? 2. CURRENT SITUATION : How...

ID alcohol exercise height male dadht momht 1 12 10 66 0 71 66 2 0 5 64 0 68 62 3 0 2 72 1 65 64 4 0 3 68 1 74 62 5 0 6 68 1 70 59 6 5 6.5 64 0 70 65 7 0 2 68.5 1 68 60 8 1.5 3 69 0 76 66 9 4.5 4.5...