Auto pistons are produced in a forging process, and the variability of the diameter is a critical factor that must be controlled. From five samples collected on 5 different days (one sample each day), each containing 10 pistons, the mean and the range of the diameters have been measured as follows: Day Mean (mm) Range (mm) 1 154.9 4.4 2 153.2 4.8 3 151.6 4.3 4 153.5 4.8 5 156.6 4.5 Assuming the confidence level 99.73%, determine the right control chart for controlling the variability of the diameter, and find its lower control limit. Note: Enter the value of the lower control limit after rounding to two decimal places