Question: ( b ) The figure shows a 3 - phase radial trarismission system. The ratings and reactances of the components are as shown. The Motor

(b)
The figure shows a 3-phase radial trarismission system. The ratings and reactances of the components are as shown. The Motor is drawing 45 MVA, 0.8 power factor lgging at a terminal voltage of 18 Kv (VM) from 20 KV substation. Considering 100 MVA base for the whole system and base voltage of 25 KV on the Generator side, Determine the Terminal voltage of the Generator (VG).
( b ) The figure shows a 3 - phase radial

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Q3. Figure Q3 shows a section of a power system where a generator supplies three identical motors over a transmission line with transformers at both ends. The ratings of the generators, transformers...

Q:

For the power system in Problem 3.41, the synchronous motor absorbs \(1500 \mathrm{MW}\) at 0.8 power factor leading with the bus 3 voltage at \(18 \mathrm{kV}\). Determine the bus 1 and bus 2...

Q:

Consider the single-line diagram of the power system shown in Figure 3.38. Equipment ratings are Neglecting resistance, transformer phase shift, and magnetizing reactance, draw the equivalent...

Q:

For the three-phase power system with single-line diagram shown in Figure 9.22, equipment ratings and per-unit reactances are given as follows: Machines 1 and 2: \(\quad 100\) MVA \(20 \mathrm{kV}...

Q:

(Question 1) A periodic voltage waveform observed on an oscilloscope across a load is shown. A permanent magnet moving coil (PMMC) meter connected across the same load reads (Question 2) With initial...

Q:

Q. 1. Explain the concept of Operations Management and describe in brief contributions made by Henry Ford and Taguchi. Q. 2. Describe the characterstics of job production and mass production. Q. 3....

Q:

Given that P1A B2 = .4 and P1A B2 = .8, find P1B2. 3.100 From a production batch with 16 items, 8 items are randomly selected for quality assurance. In how many different ways can the sample be...

Q:

the impedence values in question 4 is j0.25 and the reactance is 0.5 10 10 6 1. For the system data given below draw the single line diagram. Represent the power, voltage and impedances in per units...

Q:

This text was adapted by The Saylor Foundation under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 License without attribution as requested by the work's original creator or licensee. 1...

Q:

I attached the instruction and the article to read in PDF format. Make sure to answer all questions and each question has to have 5 answers. Thank you, r 2010 Public Financial Publications, Inc....

Q:

Hefty Corporation would like to buy mineral leases owned by Tiny Corporation for $550,000. Tiny informs Hefty that these leases are not transferable under its current contract. Given that the leases...

Q:

If 200 labor hours were required to produce the 15tunit in a production run and 60 labor hours were required to produce the 7th unit, what was the learning-curve rate during production?

Q:

a company failed to post a $ 5 0 debit to the office supplies account. the effect of this error will be that: a . the office supplies account will be overstated b . the trial balance will not balance...

Q:

Explain the expansion of the work by Hazen and Shaver and Identify how the attachment styles might look in adult relationships. Do you agree with the expansion of the work by Hazen and Shaver (and...