Can I get help with this please?

A simple definition of windchill is "a temperature that shows how cold the air feels because of the wind"; the full definition is "a still-air temperature that would have the same cooling effect on exposed human skin as a given combination of temperature and wind speed" (Merriam-Webster). In this program you will calculate and print windchills for wind speeds. You will use the National Weather Service windchill temperature index, which was effective in 2001. The previous measure was adapted to provide the following characteristics: Calculates wind speed at an average height of 5 feet, the typical height of an adult human face, based on readings from the national standard height of 33 feet, typical height of an anemometer Is based on a human face model Incorporates heat transfer theory: heat loss from the body to its surroundings, during cold and breezy/windy days Lowers the calm wind threshold to 3 mph Uses a consistent standard for skin tissue resistance Assumes no impact from the sun, i.e., clear night sky. https://www.weather.gov/safety/cold-wind-chill-chart The Program The windchill is defined for winds at least 3 miles/hour and for temperatures at or below 50 degrees. Your program will be able to calculate windchills for winds up to 60 miles/hour. You will need an array of floats for the wind speed factor, which you will use to calculate the windchill. This array will hold the wind speed factor for winds from 3 to 60 miles/hour, in locations [0] to [57]. The formula for windchill in Fahrenheit is below, with T as the temperature in Fahrenheit, and V as the wind speed factor, calculated in miles per hour: windchill = 35.74 + 0.6215T - 35.75V + 0.4275TV Your program will do the following: 1. get the array of floats to hold the wind speed factors 2. create float variables to hold the constants needed for the windchill calculation, and load those constants into registers to use in the windchill calculation 3. create a loop to do the following: 1. read in a temperature (int), stop looping when the user enters a temperature above 50 2. calculate and print the windchills for this temperature, for all integer wind speeds from 3 to 60, rounding the windchills to the nearest int: output should look like the following The windchill is defined for winds at least 3 miles/hour and for temperatures at or below 50 degrees. Your program will be able to calculate windchills for winds up to 60 miles/hour. You will need an array of floats for the wind speed factor, which you will use to calculate the windchill. This array will hold the wind speed factor for winds from 3 to 60 miles/hour, in locations [O] to [57]. The formula for windchill in Fahrenheit is below, with T as the temperature in Fahrenheit, and V as the wind speed factor, calculated in miles per hour: windchill 35.74 + 0.6215T 35.75V + 0.4275TV Your program will do the following: 1. get the array of floats to hold the wind speed factors 2. create float variables to hold the constants needed for the windchill calculation, and load those constants into registers to use in the windchill calculation 3. create a loop to do the following: 1. read in a temperature (int), stop looping when the user enters a temperature above 50 2. calculate and print the windchills for this temperature, for all integer wind speeds from 3 to 60, rounding the windchills to the nearest int: output should look like the following temp: xxx windspeed 3 4 5 windchill XXX XXX XXX 60 XXX