Computer..

control technique is explained with reference to a single phase full wave ac voltage controller circuit shown below. The thyristor switches T1 and T2 are turned on by applying appropriate gate trigger pulse to connect the input ac supply to the load for 'n' number of input cycle during the time interval ton. The thyristor switches T and T2 are turned off by blocking the gate trigger pulse for 'm number of input cycles during the interva. tOFF. The ac controller ON tome ton usually consists of an integral number of inpu cycles. T switching inverter...grade Thyristors are converter, with the difference that it is an ac waveform in this case. The current flow is bidirectional, with the current in one direction in the positive half, and then, in other (opposite) direction in the negative half. So, two thyristors connected back to back are needed in each phase. The turning off of a thyristor occurs, if its current falls to zero. To turn the thyristor on, the anode voltage must be higher that the cathode voltage, and also, a triggering signal must be applied at its gate. 1. EAN E. Tiskt Eba Tikt Three-phase, three-wire ac regulator The procedure for obtaining the expression of the mis value of the output voltage per plase for balanced star-connected resistive load, which depends on range of firing angle, as shown Inter, is described. If E, is the mos value of the input voltage per phase, and assuming the need help with python...paste indented code here... QUESTION 5 1. Implement the following: 1) Use a loop to print all the numbers of multiples of 6 and multiples of 7 from 166 to 377 inclusive. 2) Use a loop to print all the numbers of multiples of 6 and multiples of 7 from 377 to 166 inclusive. Example Output 168, 210, 252, 294, 336, 336, 294, 252, 210, 168