Question: A convergent-divergent adiabatic steam nozzle is supplied with steam at 15 MPa and 575 C. The discharge pressure of saturated steam is 1.1 MPa.

A convergent-divergent adiabatic steam nozzle is supplied with steam at 15 MPa and 575 C. The discharge pressure of saturated steam is 1.1 MPa. Assuming that the nozzle efficiency is 100% and initial velocity of steam is 85 m/s. Find the discharge velocity [25]

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

To calculate the discharge velocity of steam from the nozzle we follow these steps Given Data Inlet pressure P 1 P1 P1 15 MPa 15 textMPa 15MPa Inlet t... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

Derive an approximate expression for the total-to-total efficiency of a turbine stage in terms of the enthalpy loss coefficients for the stator and rotor when the absolute velocities at inlet and...

Question 1 A steam power cycle with regeneration as shown below on the T-s diagram employs a single open feedwater heater for efficiency improvement. The fluids mix with each other in an open...

Q. 1. Explain in brief the functions of a Finance Manager? Q. 2. Explain various methods of raising fund with their merits and demerits. Q. 3. Discuss in detail various factors affecting the dividend...

Question 5 Question 1 An ideal Brayton cycle, operating between the pressure limits of 1 bar and 6 bar, has minimum and maximum temperatures of 300 K and 1500 K. The ratio of specific heats of the...

HW-30 (See HW-17 and HW-28) A power cycle operating steadily is shown below. The boiler (a heat exchanger to boil liquid water) produces steam at an absolute pressure of 10 MPa and a temperature of...

Republic of Iraq Ministry of Higher Education and Scientific Research University of Technology Chemical Engineering Department MODELING AND SIMULATION OF FCC RISERS A RESEARCH SUBMITTED TO THE...

Homework-Week #11 Submit on Gradescope ME 200-Thermodynamics I me200-Purdue Due by 11:59 p.m. EDT on November 3, 2023 HW-28 (See HW-17) A power cycle operating steadily is shown below. The boiler (a...

A Rankine cycle power plant burns natural gas to raise steam ( i . e . , the working fluid is water ) . The combustion temperature is 1 8 5 0 K and the plant rejects waste heat to a lake at 2 2 C ....

combustion temperature is 1 8 5 0 K and the plant rejects waste heat to a lake at 2 2 C . The plant is designed to produce 2 5 0 MW of electrical power when operating at rated capacity. Net...

Consider a cogeneration plant Steam enters the turbine at 9 MPa and 600 C. Some steam is extracted from the turbine at 500 kPa for process heating The remaining steam continues to expand to 7.5 kPa....

Describe an alternative to using ROI or residual income to measure investment-center performance.

Answer the following questions: 1. The internet is the driving force behind developments in telecommunications, networks, and other information technologies. Do you agree or disagree? Why? 2. What is...

what is the pre - established fixed payment per patient per unit to time that is paid to help care providers?

1) Suppose Big Als Pizza, Inc. just paid a dividend of $0.75. It is expected to increase its dividend by 4% per year. If the market requires a return of 12% on assets of this risk, how much should...