Question: Consider pin support as point A and the roller support as point B . Point C is the midpoint of the beam at 4 m

Consider pin support as point A and the roller support as point B. Point C is the midpoint of the beam at 4m. Use the conjugate beam method to find the displacement at C.
Consider pin support as point A and the roller

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

The following beam is supported in two locations: a pin support at point A and a roller support at point B. (a) Determine the reaction forces at points A and B. (b) Draw the shear force diagram for 0...

Q:

QUESTION 1 Question 1 (25 marks) A statically determinate beam is shown in Figure 1. Point A has a pin support and point C has a roller support. Draw the influence lines for (a) the vertical reaction...

Q:

A statically determinate beam is shown in Figure 1. Point A has a pin support and point C has a roller support. Draw the influence lines for (a) the vertical reaction at A (9 marks) (b) the shear at...

Q:

Q3(1). The beam is supported by a pin support at point A and a rocker support at point B, and the length is / = 6.6 ft. It has a cross section shown in the image with h = 8.6 in. It is subjected to a...

Q:

Figure Q1 shows an overhanging beam with pin support at point A and roller support at point B. The beam is subjected to uniformly distributed load from point A to point B and concentrated load at...

Q:

Consider the following beam in Figure P2, which is supported by pin support at point A and roller support at point D. The structure is loaded with a diagonal force P-19 kN (orientated at 90 to, and...

Q:

Consider the below given beam which is in static equilibrium by a pin joint at point A and a roller support at point D. Based on the loading on the beam (no load/force is applied along the...

Q:

Problem 2 Consider the following beam in Figure P2, which is supported by pin support at point A and roller support at point D. The structure is loaded with a diagonal force P=19 kN (orientated at 90...

Q:

A bone specimen is to be tested under 3-point bending. A model of the test set up in the figure below. The bone is modeled as a prismatic beam with a hollow cylindrical cross-section that has an...

Q:

The beam shown in Figure 2.1 is supported by a fixed support at point C and a roller at point A. It also has an internal hinge at point B. The beam supports a point load at point D, a moment at point...

Q:

Do you think the requirement that CEOs and CFOs sign off on their company accounts will increase investor confidence in those accounts? Why or why not?

Q:

A 100-V-rms voltage is applied to a series RC circuit. The rms voltage across the capacitor is 80 V. What is the voltage across the resistor?

Q:

Purple Construction is evaluating Project X , a 2 - year project that would involve buying equipment for $ 3 6 0 , 0 0 0 that would be depreciated to $ 0 over 2 years using straight - line...

Q:

Forecasting for Paris Caf January Month Sales ('000s) $ 37 February $ 42 March $ 39 April $ 29 May $ 49 June $ 40 July August September October $ 39 $ 41 $ 45 ? 1. What is the forecast for October...