Question: Consider that a solution with a density of 1 . 6 g / cm 3 flows through a horizontal duct. The inlet section has a

Consider that a solution with a density of 1.6 g/cm3 flows through a horizontal duct. The inlet section has a diameter of 6 cm, the pressure is 345 KPa and the flow velocity is 18 m/s. In section 2, the diameter is 8 cm. Determine the pressure in section 2. Answer
KPa

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

ANSWER ALL QUESTIONS. BE SURE TO ANSWER 2 -1 C What is the difference between the macroscopic and microscopic forms of energy? 2-2C What is total energy? Identify the different forms of energy that...

Q:

Please I need help with the questions for Calculations (Part ), Calculations (Part 2), the graph, and questions 1-2 on the last page. THE DATA TO DO THE CALCULATIONS ARE PROVIDED IN THE TABLES. THATS...

Q:

12B please circle the answers please circle the answers please circle the answers please circle the answers please circle the answers please circle the answers please circle the answers please circle...

Q:

1. Water at 93.3C is being pumped from a large storage tank at 1atm abs at a rate of 0.189m3/min by a pump. The motor that drives the pump supplies energy to the pump at a rate of 1.49kW. The water...

Q:

I need help with this lab. Please answer questions for pages 4-7. Freefall Purpose: We will measure the value of 'little g', or the acceleration due to gravity on the surface of Earth. The particular...

Q:

Please let me know if you need anything, thank you. 2a. Schematically illustrate the subsurface conditions and calculate the effective vertical and total horizontal stresses at Point A before...

Q:

Due Sunday, 11/20: Problems from Zimmerman text: 2-11, 2-44, Case 2-3, 7-7, and 7-20 Chapter Two The Nature of Costs Chapter Outline A. Opportunity Costs 1. Characteristics of Opportunity Costs 2....

Q:

ANSWER ALL QUESTIONS. WILL GIVE A GOOD RATING FOR A CORRECT ANSWERS ONLY 2-35E A spring whose spring constant is 200 lbf/in has an initial force of 100 lbf acting on it. Determine the work, in Btu,...

Q:

Please help! 3.4 Projectile Motion 27 .A ball is thrown horizontally from the top of a 60.0-m building and lands 100.0 m from the base of the building. Ignore air resistance. (a) How long is the ball...

Q:

I need help solving this deliverable for a lab report I have: Calculate and report the convective heat transfer coefficients for each rod position. Moreover, discuss the underlying physics that...

Q:

A long wall panel 6,200 ft long with a face length of 820 ft is planned for a seam 1,300 ft deep and 16.5 ft thick. Mining is full seam height. Assume UK conditions apply. Find: 1 The maximum...

Q:

A double replacement reaction between lead(IV) nitrate and sodium chloride will produce lead(IV) chloride and sodium nitrate. If 1.02 moles of lead(IV) nitrate is reacted, how many grams of sodium...

Q:

A hazard ratio of 0 . 7 6 indicates a Group of answer choices risk increase of 7 6 % risk increase of 2 4 % risk reduction of 2 4 % risk reduction of 0 . 7 6 %

Q:

8. In Question 6, there was no penalty for a deteriorating balance sheet. In other words, the debt level (and thus the likelihood of default) had no bearing on the interest rate. That is rather...