Construct the Circuits Shown. For Series Circuit & Parallel Circuit R1 :470 Ohms, R2: 100 ohms, R3: 3.3K Ohms..on the Series/parallel #3 use same values, just put 10 ohms for R4 if possible

pect ITEM (S): Measure voltage, current, resistance, and continuity JE G STUDENT PERFORMANCE GOALS: Construct the circuits on the following pages. Compute circuit values and use the multimeter correctly. OBJECTIVE: Use ohmmeter to check for open or short circuit. The test instruments used to check continuity. Connect voltmeter and ammeter into an electric circuit. PROCEDURE: 1. Students will construct the circuits shown using components in the classroom as directed by the instructor. Students will then compute and enter the requested values. 2. Student will perform actual measurements of the circuit and components with the VOM and enter them in the correct locations. 3. Record the measured values at the proper location on the circuit diagram. 4. Some measurements on some circuits will not be physically possible, and TO therefore must be calculated. 5. Use FAA-H-8083-30A to assist you with resistor values. SCORING: Each circuit is worth 20 points. SERIES CIRCUIT Computed Computed Measured ET E, E IT RT E2 Measured E2 12- 12- ET RT 13 13 R2 PARALLEL CIRCUIT ETMAM HO STUTITENINOITAIVA Computed 18 R2 R3 E1 Computed 11 R1 Et It E, bro . E2 E, M Rt E2 12- 13 12 R , R 2 R2 ET E3 13 RT two hoda o nego jot No R3 352020021 SERIES /PARALLEL mu S1 Computed Computed Et RI II It O R Rt R3 RA E2 12 R2 E2 EA MM 12- E3 ET- RA 13 R3 IT E4 RT E4