Control panel Control panel display User command and data Display information Alarm type SecureHome Software Alarm Sensar status Telephone number tones Sensors Telephone line The SecureHome security framework is illustrative of numerous PC based items and frameworks. The item screens this present reality and responds to changes that it experiences. It additionally connects with a client through a progression of composed sources of info and alphanumeric display. a. Now design a level 1 diagram using the following scenario. Control panel send user command and data to Interact User process. This process sends a configure request to configure management process and start/stop signal to Activate/Deactivate system process. Configuration information datastore receives configuration data and sends it to the Display messages and status process. Display messages and status process also receive A/D messages and send display information to control panel display. On the other hand Monitor sensor process receives sensor status from sensor and configuration data from Configuration information datastore. It also sends alarm type information to Alarm, sensor information to display messages and status and telephone number tones to telephone lines. b. Now design a level 2 diagram for the Monitor sensor process based on the following scenario. Read sensor sub process receive sensor status and select sensor ID, type to setup assessment process. This process also receives configuration data and generates alarm type and telephone number tones. Finally it sends sensor ID, type, location to Format for display process which ultimately creates sensor information. Make sure the levels are balanced and mention if you find any error