Could you please explain the code I mean each step by providing a comment at each lin.

This in C++ language.

for a temperature sensor in Arduino

const int sensorpin = A.0: const tloat baselineTemp =24.0, void setupe) ( Serial beginl96oget. Jor (int pinNumber * 2; pinNumber s 5; pieNumberie+) f pinModelpinNumber,DurPUT): dieitalWrite(pinNumber, LoWl; 1 1 void looplik int vensorvalnanaloghead|senvee P inli; Serial.primtl-Sehsor value: "1. Serial printigensorvail. flat voltage = (sensorval /5/102400l. float semperature a (woltage) 100 ; Serial printle" Wolts: "ts Serial grint(voliage): Serialgrinte", degrees c : "I. sepiksciptiplemperature i. if \{temperabure baseline Temp) i digitahrite(2,LOW): digitahite 3,LOW : digitalWrite[4,LOW]: eve if (qemperature sn baselinefemp s\& temperature s baseline Temp+20) 1 digitahirite[2,HIGH): digitalWrite[3,L0W]: dipitar Write[4,10W]: ] else it (temperature > b baselinefemp 20a s temperature a baseline femp+40) t digitalWirite(3,HISH/ digitalWrite(4,LOW): else it (temperature >u baselineTemp+40) } digitalWrite(2, HIGH): digitalWrite(3.HiGat): digitalWrite(4,HIGH), ) delay(1000:)