Question: Describe how physical systems can be converted into equivalent electrical circuits by using the force - voltage analogy.

Describe how physical systems can be converted into equivalent electrical circuits by using the force-voltage analogy.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Could you please solve all parts. Also, this question is related to heat transfer (chemical engineering). The figure shows a section of a wall that repeats with the same pattern both above and below....

Q:

With a particular number of towers the chances of incidence of lightning on power conductor scan be minimized by placing a ground wire at the top of the tower structure.. The tower presents a...

Q:

This streamer is very intense where the current varies between 1000 amps and 200,000 amps and the speed is about 10% that of light. With a particular number of towers the chances of incidence of...

Q:

The system is, then, equivalent to line bifurcated at the a towerpoint.We know that the voltage and current transmitted into the tower will depend upon the surge impedance of the tower and the ground...

Q:

The tower presents a discontinuity to the travelling waves; therefore they suffer reflections and refraction. The system is, then, equivalent to line bifurcated at the a towerpoint.We know that the...

Q:

Once the stepped leader has made contact with the earth it is believed that a power return stroke(Fig. 1.6(c)) moves very fast up towards the cloud through the already ionized path by the leader....

Q:

Please answer the following in detail given the lab report and data shown below: 1. Resistance, R, is defined using R = V/I where V is the voltage across a resistor, and I is the current. R is...

Q:

It is, therefore, desired that for good line design high surge impedances in the ground wire circuits, the tower structures and the tower footing should be avoided. High saturation induction (to...

Q:

We know that the voltage and current transmitted into the tower will depend upon the surge impedance of the tower and the ground impedance (tower footing resistance) of the tower. If it is low, the...

Q:

If it is low, the wave reflected back up the tower will largely remove the potential existing due to the incident wave. In this way the chance of flashover is eliminated. If, on the other hand, the...

Q:

Consider the following simultaneous equation model: YB10 + B12Y21+X + U Y21 = B20 + B21 Y1 +022X21 + U21 (a) Obtain the reduced-form equations for this model. (b) What is the relationship between the...

Q:

Given the circuit in figure, determine the two networks obtained by replacing (a) The primary and the ideal transformer with an equivalent circuit and (b) The ideal transformer and the secondary with...

Q:

Use simple linear regression, with total cost as the dependent variable ( y ) and volume as the independent variable ( x ) . The model y = b 0 + b 1 x will give you estimates of b 1 = the per unit...

Q:

6:35 On January 2, 2018, Archer Company, a skateboard manufacturer, installed a computerized machine in its factory at a cost of $179,000. The machine's useful life was estimated at four years or a...