Question: Design a elevator controller which operates in 7 floors. The controller has following specifications States IDLE: Lift is waiting for a call. MOVING _ UP:
Design a elevator controller which operates in floors. The controller has following
specifications
States
IDLE: Lift is waiting for a call.
MOVINGUP: Lift is moving upwards.
MOVINGDOWN: Lift is moving downwards.
STOPPEDATFLOOR: Lift has stopped at a floor.
DOOROPEN: Lift's doors are open.
Inputs:
Call Up: Call button pressed to go up
CallDown: Call button pressed to go down.
DoorOpen: Signal indicating the door is open.
DoorClosed: Signal indicating the door is closed.
Outputs:
MotorUp: Signal to drive the motor upwards.
MotorDown: Signal to drive the motor downwards.
DoorOpenSignal: Signal to open the door.
DoorCloseSignal: Signal to close the door.
Draw the state diagram and write a Verilog code for the same.
Step by Step Solution
There are 3 Steps involved in it
1 Expert Approved Answer
Step: 1 Unlock
Question Has Been Solved by an Expert!
Get step-by-step solutions from verified subject matter experts
Step: 2 Unlock
Step: 3 Unlock
