Design a microcomputer system using a uP 8086 10 Mhz. This system must have a Coprocessor 8087, a parallel connector, a serial connector, ADC and DAC connector for data conversion, a 16 byte seven segment display, a 64-key matrix keyboard, a USB connector thru a DMA for high speed data transfer. A special connector to connect a printer. The system must have an interrupt controller. The main memory size will be 1 Mbyte. Show all the diagrams needed to construct your design, show a memory map and the type of memory you will need for you design including the configuration and decoding system. You must include the programming needed for set up the complete system. Use pseudo code for each driver and programming each of the interface needed