Question: Design a system to pump water at 80C from a water heater to a water supply system. washing, as shown in Figure 2.1. The desired

Design a system to pump water at 80C from a water

heater to a water supply system.

washing, as shown in Figure 2.1. The desired minimum flow rate is 750 L/min (198 gal/min).

Additionally, carry out the request at the points

indicated for the delivery of the project (sheet of calculation, resistance curve, etc.

The proposed sizes and material of the pipe.

The location and specification of the centrifugal pump suction diameter, discharge diameter, rotation speed, impeller diameter, power, efficiency, etc).

The length of the pipe for all parts of the system.

Proposal for types and number of valves and accessories.

A careful drawing of the piping layout (no hand drawings) or erasures.

A list of materials needed to implement the system. The analysis of the pressure in the pertinent points.

Determine the NPSHR.

Calculate from the available NPSH and show that with the suggested arrangement no there will be cavitation.

Design a system to pump water at 80C from a water

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

What is the citation of a 1993 ALR annotation that discusses the admissibility of polygraph test results in an action for malicious prosecution? What Am. Jur. 2, Evidence research references are...

Design a system to pump water at 80C from a water heater to a water supply system. washing, as shown in Figure 2.1. The desired minimum flow rate is 750 L/min (198 gal/min). Additionally, carry out...

Design a system to pump water at 80C from a water heater to a washing system, as shown in Fig. 13.56. The desired minimum flow rate is 750 L/min (198 gal/min). FIGURE 13.56 Design Problem 2. Vent...

Design a system to pump water at 80C from a water heater to a washing system as shown. The desired minimum flow rate is 750 L/min (198 gal/min)

X = 9, Y = 1 Question: A new salt factory is being developed at a remote location in salt affected region of Victoria. This factory does not have access to utilities such as grid electricity, piped...

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

University of Hartford Department of Civil, Environmental and Biomedical Engineering CE 320 Water Resources Engineering Spring Semester 2017 Lab #5 - Pump Performance Characteristics Report Outline...

ATTEMPT ALL QUESTIONS. BE SURE TO ANSWER A body with mass m = 1 2 kg is attached to the end of a spring that is stretched 2 m by a force of 100 N. Furthermore, there is also attached a dashpot4 that...

Hello, you already did chapter 1 and 2 of my MASTERS Thesis already for me. (See attached) So normally you know masters thesis consist of 5 chapters right ??..... But in this case my thesis will be 4...

Assignment 1 (a) - 4 Marks 1. Identify at least 10 types of hazards that are to be found in your workplace/industry. Hazard: potential source of harm .. a state or set of conditions of a system ......

EXPERIMENT 1 Allow the temperature to rise to a desired temperature ] ( For safety the temperature controller is set from factory at Maximum operating temperature of 8 0 C ) . Switch on the hot water...

There is a square membrane of area S. Find the number of natural vibrations perpendicular to its plane in the frequency interval from w to w + dw if the propagation velocity of vibrations is equal to...

Need help in writing this program in Javascript. Take the function f(x) = ln(sin(x)) + 1 and find the integral from x=0.5 to x=2.5 you will need to define four variables for me to test the program:...

The manager of the Wales division of Pieces and Clothing, Inc., is considering making an investment to expand operations. The investment has the following projections: Revenues = $ 1 0 0 , 0 0 0 Cost...

fill out the blank for activity 6.9 or their monthly savings for premiums of their insurance. Health Plan Overview PLAN FOR SUCCESS WHAT In Your Cu Once you get insurance, add the premiums to your...

3 If you were giving a speech to an audience armed with clickers, what kinds of questions would you ask? How might the audiences responses change the nature or style of your speech? Could you make...

A In what ways were the public lives of McCarthy and Fox similar? How were they different?

Give proper credit to sources and take responsibility for your speech?