Draw and design a basic desk and chair and sketch hand drawings. These drawings should be clear enough that someone could build this set easily. The following conditions must be met

That chair should have a minimum of $6$ parts $(4$ legs, seat, back$)$

a$.$ If all legs are the same, only need to draw it once

The desk should have a minimum of $5$ parts $(4$ legs, top$)$

a$.$ If all legs are the same, only need to draw it once

Additionally, add a desk accessory $($pencil holder, etc...Be Creative!$)$ that is included with your drawing package.

The components should be assembled in some way $($Screws or epoxy$/$glue$)$ depending on your design. If you use screws, use the internet $($

Lowes.com,

Homedepot.com, etc.$)$ to find a good type$/$length for your application. If you use epoxy or glue, take that into consideration in your design.

A full parts list should be included, including material of each component and screws.

Each drawing should have a title block that includes the following:

a$.$ A company name $($make one up$!)$

b$.$ Drawing Title

c$.$ Drawing Number

d$.$ Revision Number

e$.$ Drafted By

f$.$ A general tolerance $($could vary based on your material of construction$).$ You do NOT have to do tolerances for individual dimensions.

Isometric is NOT required for each part

BONUS $(5$pts$)$: Draw an Isometric of your entire assembly. $($desk$,$ chair, accessory$)$

You will be graded on the following:

Showing proper views necessary to build the object. You are welcome to use anything discussed in Modules $1-7$ but drawings MUST BE CLEAR. I should be able to easily build your design after I review the drawings. $(40$ pts$)$

Dimensions should be shown, but don't over dimensions. These dimensions must make sense $($Ex: your chair can't be $10$ft tall$).$ Reference Module $6-7$ as needed. $(20$ pts$)$

Use English units! $($inches$,$ ft$,$ etc.$)$

Title block should be complete $(10$ pts$)$

Parts list should be complete $(10$ pts$)$

General quality of drawings $(20$ pts$)$