A plate 100 mm wide and 10 mm thick is
1. The stepped shaft in Figure Ql is used to transmit a power of 8 kW at 160 rev/min.
The viscosity of liquids can be measured through the use
a 65 mm diameter solid shaft is to be welded
In a quasi-equilibrium process in a closed system, a gas
A steam turbine producing 55 MW power is fed with
A circular steel bar 50 mm diameter and 200 mm
The following bracket is bolted to a fixed wall support
In the scaffolding system shown in Fig. 3.17, loads x1
3. Kerosene is to be preheated in a double-pipe heat
A pump supplies oil at 20 gpm to a 2-
A man is found dead in a room at 16°C.
The graph of f(x) is shown below. The domain of
What do you mean by biaxial strength of orthotropic lamina ? Compare the maximum stress theory with
Describe the impact on air flow, maximum torque, and maximum
Mass 1 is moving according to the law x=3t^3. Assuming
Write down the names of following crystallographic planes. (a) (b).
Explain the manufacturing process for sheet molding compound (SMC). Write
Describe in a general way equilibrium equations to find reactions
Distinguish among quality planning, quality assurance, and quality control and