Question: evaluate As shown in the figure, an ac source whose ms voltage is 80 V is in series with a 100-0 resistor and a capacitor

evaluate

As shown in the figure, an ac source whose ms voltage is 80 V is in series with a 100-0 resistor and a capacitor whose reactance is 200 at the frequency of the source. What is the rms voltage across the capacitor? R=1000 Vig = 80 x,=2000 66V O FOV O 68V O 74V oO 72V

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Mathematics Questions!

i need al the work and lab simulations and pre labs and calculations. LAB SIMULATIONS MUST BE ON PROTEUS ISIS INTRODUCTION: Linear circuit elements resistors, capacitors, and inductors are the...

1 )A coil of resistance 20 and inductance 100 mH is connected in parallel with a 50 F capacitor across a 30 V variable-frequency supply. Determine (a) the resonant frequency of the circuit, (b) the...

Open your browser and go to the simulation. You will see three things: PART 2: Voltage vs. time graph In this part we shall focus on the voltages shown in the bottom-left graph. 1) Bottom-left you...

Hi, I need help with completing this assignment; here is the link for it, https://phet.colorado.edu/en/simulations/circuit-construction-kit-ac PhET Simulation: This lab uses the Circuit Construction...

PhET Simulation: This lab uses the Circuit Construction Kit AC simulation from PhET Interactive Simulations at University of Colorado Boulder. After launching the simulation, please select R-L-C...

Please help me with the following A solenoid of radius 3.5 cm has 480 turns and a length of 25 cm. (a) Find its inductance. Em (in) Find the rate at which current must change through it to produce an...

RC Circuits 1. A large capacitor has a capacitance of 1 F. The capacitor is attached to a 10 V battery and charged to its maximum charge. What is the charge Q stored in the capacitor? 1. 0 C 2. 0.1 C...

I need help to fill out table 3 on page 88, and question 1 to 3 on page 89 to 90 Vo Monitor Run Monktor Run Output Voltage, Ch 01 (v) Output Voltage, Ch 01 (v) IbWNNOHNWI -3 -2 - 1 1 0.0001 0.0002...

Physics: Charging and Discharging a capacitor Lab Use details from Part A and Part B to answer Questions in Part C Part A = References (Protocol + Instructions + Procedure + Formulas ) and Reference...

Physics Lab : Charging and Discharging a capacitor Use information provided from Part A (References) and Part B (Data) to answer Questions in Part C Part A = References (Protocol + Instructions +...

A steel band saw, 20 mm wide and 0.6 mm thick, runs over pulleys of diameter d. (a) Find the maximum bending stress in the saw if d = 500 mm. (b) What is the smallest value of d for which the bending...

If in a triangle ABC, sin(A) = 1/5, cos(B) = 2/7, then cos(C) =

Training in PHI policies and procedures means that: Select one: a. every member of the facility workforce must be trained. b. documentation of training is not required. c. only individuals employed...

The efficiency of labor is a term that does not reflect the: A) education of the labor force. B) skills of the labor force acquired through on-the-job training. C) health of the labor force. D) high...