)uestion S (CCP Module) a) True or false In compare mode. the CCPpin must be configured as an output pin. c) d) Which register is used to choose the timer for Capture mode? True or false We can use only Timer O and Timer 3 for Capture mode. True or false In Capture mode, the CCP pin must be configured as an input pin. True or false In PWM mode. thc CCP module uses Tuner I. (1 ( I point) (l point) (l point) (l point) Noting that PR2 (the period register' is an and PR2 x 4 x N)) I , where Fosc is the frequency of oscillation of the microcontroller. Fpwrn is the desired pulse width frequency and N I or 4 or 16) is the prescalc factor of the timer, Assuming Fosc 10 MHz. Fpwm = I kHz and that we want a duty cycle, find thc following: a) b) c) e) A suitable value for N The value of register PR2 (round to the nearest whole nurnt*r) The value of register CCPR I L two-bit for DCIB2:DClBt (4 points) (4 points) (3 points) Write an XCS program to genet-atc thc PW'M signal on the CCPI pin Of the PICISF4S2 (10 points) microcontroller.