Fill in each blank space with the missing answer Place the missing words to complete the following statement about replacing a coil spring using the following words. Missing Words: arm, ball, bungee, compressors, control, forcing, joints, lowered, plates, positioned, remove, spring, stabiliser, support, washer To remove a coil spring, raise and Select... the vehicle by its frame. Let the control Select... hang free. Remove wheels, shock absorbers, and Select... links. Disconnect the outer tie-rod ends from their respective arms. Select... the brake caliper and support it with a wire or Select... cord so it does not hang on the brake hose. Unload the ball Select... with a roll-around floor jack. Jack under the lower Select... arm from the opposite side of the vehicle. This allows the jack to roll back when the control arm is Select... . Position the jack as close to the lower Select... joint as possible for maximum leverage against the spring. The Select... is ready for the installation of the spring compressor. There are many different types of spring Select... . One type uses a threaded compression rod that fits through two Select... , an upper and lower ball nut, a thrust washer, and a forcing nut. The two plates are Select... at either end of the spring. The compression rod fits through the plates with a ball nut at either end. The upper ball nut is pinned to the rod. The thrust Select... and forcing nut are threaded onto the end of