Fit the Velocity/Time data with a linear equation (y = At + B). Record the results of your fit here: Linear Curve Fitting Parameters A = B = Measured acceleration of the system = How does this measured acceleration compare to the calculated acceleration for this mass distribution? b) What if we had the situation where M1 = M2 =50 g. What would be the expected acceleration? Expected acceleration after release = Reset the simulation and balance the two hanging masses so that M1 = M2. Measure the acceleration of this system after hitting "Start". Use the velocity vs time data to indicate the acceleration of the system. You may select a subset of the data to determine the acceleration. Note the system will not stop running in this configuration. You will need to hit reset to stop the simulation. Copy any needed data before hitting reset. Describe how you used your data to determine the acceleration. Measured acceleration after release = 8