G-Code Homework9 Write the G-code necessary to move the tool from the origin to cut the path shown below, Once the path is finished the tool should be sent back to the origin (0,0,0) Use a spindle speed of 1750 rpm, tool #2, and a feed rate of 10 then 50, Each square in the grid below represents 10 mm.The depth of the cut should be 6 mm. Assume that your tool starts at (0,0,0). Start with absolute coordinates for the first line, then change to incremental coordinates, and alternate G90 with G91 until the figure is finished. Start here (0,0) | H 03 51- 50 GOOND