Question: Given an air - filled transmission line binomial matching network designed to match a 5 0 Ohm transmission line to a load impedance of (

Given an air-filled transmission line binomial matching network designed to match a 50 Ohm transmission
line to a load impedance of (100+ j50) Ohms, where a transmission line section of length L1 with a
characteristic impedance of 50 Ohms is connected, determine the values of L1, Z1, Z2, Z3.
Find out the reflection coefficient at the AA, BB and CC end
Given an air - filled transmission line binomial

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Once the stepped leader has made contact with the earth it is believed that a power return stroke(Fig. 1.6(c)) moves very fast up towards the cloud through the already ionized path by the leader....

Q:

With a particular number of towers the chances of incidence of lightning on power conductor scan be minimized by placing a ground wire at the top of the tower structure.. The tower presents a...

Q:

The system is, then, equivalent to line bifurcated at the a towerpoint.We know that the voltage and current transmitted into the tower will depend upon the surge impedance of the tower and the ground...

Q:

The tower presents a discontinuity to the travelling waves; therefore they suffer reflections and refraction. The system is, then, equivalent to line bifurcated at the a towerpoint.We know that the...

Q:

We know that the voltage and current transmitted into the tower will depend upon the surge impedance of the tower and the ground impedance (tower footing resistance) of the tower. If it is low, the...

Q:

This streamer is very intense where the current varies between 1000 amps and 200,000 amps and the speed is about 10% that of light. With a particular number of towers the chances of incidence of...

Q:

If it is low, the wave reflected back up the tower will largely remove the potential existing due to the incident wave. In this way the chance of flashover is eliminated. If, on the other hand, the...

Q:

Figure 5 shows a RF amplifier. The datasheet provides the S-parameter at 390MHz is given as below: Su=0.39 / 163 S21 = 5.1962 S12= 0.05/61 S22 0.36-38 ZG 50 2, generator output impedance. Zo=75 02,...

Q:

It is, therefore, desired that for good line design high surge impedances in the ground wire circuits, the tower structures and the tower footing should be avoided. High saturation induction (to...

Q:

The sensitivity of a relay refers to the smallest value of the actuating quantity at which the relay operates detecting any abnormal condition. In case of an over current relay, mathematically this...

Q:

Referring to Exercise 9.7, construct a 99% tolerance interval containing 99% of the miles traveled by automobiles annually in Virginia.

Q:

:1 Design a circuit that uses nand, nor and inverter gates to provide the exclusive or function p41 #2.7: Look at Web sources, such as Wikipedia, to answer the following question: 2 when a chip...

Q:

A portfolio manager realizes a substantial capital loss when selling a large security position that was acquired 2 years ago. Because of this action, the NAV of the fund: Is unaffected Will decrease...

Q:

(1)Convert from ( Base 10) - 3 1/4 into Binaryscientific, IEEE 32-bit and IEEE 64-bit (2) Convert from Decimal 33 into 8-bitBinary(2s complement) and 2-digit Hex(2s-complement) (3) Convert from 8...