Hands on: In Logixpro do the following programs. Let the instructor see your finished work, you will only have one chance to get this correct. Make sure your program is correct before calling the instructor. When the instructor approves you answers, get a copy of your program. This exercise will be done in the $\frac{1}{O}$ simulator. Points will be deducted if you don't have instructions labeled. Each question is worth $5$ points.

Program# $1$

$47-$ When I press and hold $($no latch$)$ a normally open pushbutton connected to $1$:$\frac{1}{00},$ The light on $0$:$2/00$ turns on immediately, However the light on $0$:$2/01$ doesn't turn on until $10$ seconds has passed.

$48-$ In the same program when I let go of the switch connected to I:$/00,$ the light on $0$:$2/01$ turns off immediately and the light on $0$:$2/00$ turns off after $12$ seconds.

$49-$ In the same program, pressing i:$1/003$ times the light on $0$:$2/02$ will turn on and stay on indefinitely until you press I:$\frac{1}{01}$ and the whole cycle can begin.

Program # $2$

$50-$ You will create a new program, When I press I:$1/00$ a light $(0$:$\frac{2}{00})$ will turn on and stay on until I press I:$1/01.$ I:$1/01$ will stop everything.

$51-$ In the same program, when light $0$:$2/00$ the following sequence happens: All of this happens when the light is energized. $($Only one timer can be used!!$)$ Hint; Compare.

After $5$ sec O:$2/01$ turns on

After $10$ seconds $0$:$2/02$ turn on

After $20$ seconds $0$:$2/03$ turns on

$52-$ In the same program, once the lights have gone through this sequence the will stay on until the stop switch is pressed. The lights should not be continually turning on and off after the initial $20$ seconds is over. Between $8$ seconds and $16$ seconds, light $0$:$2/03$ turns on $($light turns off after$)$