Help me for this tasks

This case study requires the student to accomplish the following tasks: Set up the physical layout of the network using the diagram and accompanying narrative Correctly configure Network Devices with a basic configuration . Correctly configure VLANS Correctly configure IEEE 802.1q trunking Correctly configure RIP Version 2 Correctly configure DHCP Correctly configure NAT Create and apply access control lists (ACL'S) on the appropriate routers and interfaces . . Troubleshoot and test the connectivity between all devices Provide detailed documentation in a prescribed form, as listed in the deliverables section Scenario: Rockford PLC is a large company that specialise in the manufacture of several models of cars. The company has been actively new employees throughout the year. Rockford realises that to aggressively compete in its market, the company needs change to its infrastructure that will support new models of cars and Internet access, allowing them to increase their productivity and to follow market trends. Rockford wants to use the internet to gain clients and find new opportunities. Rockford PLC needs a network to be designed and implemented; the company has locations in four cities. All of the locations will be connected using leased-line (T1) serial links. All four locations will use RIP Version 2 routing process. Also, the default static route must be used to access the internet. One location, Tripoli Centre, has a large and complex LAN. Due to the size and complexity, the company wants to create VLANs to control broadcasts, enhance security, and logically group users. The company also wants to use private addresses throughout the Autonomous System, DHCP over most of the LAN segments, Static and Dynamic NAT implemented for Internet connectivity. The company also wishes to limit Internet access to Web traffic and email while allowing multiple protocols (not all) within its own WAN. Although private addresses (RFC 1918) will be used, the company appreciates efficiency and address conservation in design. To minimize wasted address space, they have requested VLSM to be used when appropriate. You are a junior network engineer and have been requested by a Rockford PLC to design an appropriate addressing scheme to fit their network requirements. Benghazi GO/O G0/1 DCE S0/0 Benghazi LAN 90 hosts Nat Outside 200.100.10.64/26 Nat Inside 172.22.192.0/20 VLAN 2 WAN 3 S0/0 S0/1 Tripoli Centre DCE GO/O G0/1 VLAN VLAN VLAN 99 Tripoli Centre LANS About 300 hosts WAN 2 $0/0 Internet (Use a Server to simulate the internet 209.1.1.2/30) 2 - VLAN 99: 5 devices (Management VLAN) - VLAN 2: 100 hosts (Sales) - VLAN 3: 45 hosts (HR) GO/O 209.1.1.1/30 G0/1 S0/1 DCE ZSoro G0/1 WAN 1 Tripoli Web Server Tripoli LAN 30 hosts - VLAN 4: 150 hosts (Production) Assign the appropriately sized subnet to the Zawiyah, LAN (50 hosts). Zawiyah GO/0 Phase 1: Addressing the WAN & LANS Use the following instructions to complete Phase 1: Use 172.22.192.0/20 for internal addressing. Apply/30 subnets on all serial interfaces, using the last available subnet. Assign an appropriately sized subnet for the Tripoli Centre LANs, has about 195 devices: G0/1 Zawiyah LAN 55 hosts Assign an appropriately sized subnet for the Tripoli (headquarter), LAN (30 Hosts). Assign an appropriately sized subnet for the Benghazi LAN (90 Hosts). Document the addressing scheme in tables. Note: Addresses will be assigned dynamically to hosts; refer to the DHCP section to this document for details.