help solve

Refer to Table S5 1 - Facton for Comouling Control Chart Umits i3 sigma) for this problem. Aulo pastons at Wenming Chungs plant in Shanghai are produced in a forging process, and the dameter is a crifcal factor that must be controted. From sarnple scees of 10pistons produced each day, the mean and the range of this dameler have been as follow: a) What is the value of x ? x= men (round your response to two decimal places). x=mm(roundyourresponsetotwodecimalplaces). b) What is the value of R ? R=mm(roundyourresponsetotwodecimalplaces). c) What are the UCLx and LCLx using 3-sigma? UpperControlLimit(UCLx)=LowerControlLimit(LCLx)=1mm(roundyourresponsetotwodecimalplaces).nm(roundyourresponsetotwodecimalplaces). d) What are the UCLR and LCLR using 3-sigma? Upper Control Limit (UCL CLR)=mm (round your response to two decimal places). Lower Control Limit (LCLR)=nm (round your response to two decimal places). e) If the true diameter mean should be 155mm and you want this as your center (nominal) line, what are the new UCLx and L2 Upper Control Limit (UCLx)= imm (round your response to two decimal places). Lower Control Limit (LCLx)= mm (round your response to two decimal places)