Hi. i have this course project that needs to be done. I need it by Thursday. The requirements for the project are:

Create one decision tree and a fault or event tree that would support the exploration of risk for one of the above projects. The decision tree must be created to support a major risk-related decision likely to be faced by the project. The fault or event tree should offer at a minimum a listing of potential risks and impacts in the event of two smaller failures. For example, a smaller failure could be the loss of water pressure or a fire in a construction project rather than examining what risk was involved with the collapse of the construction project.

Write a discussion of the risks that supports the fault tree, event tree, or decision tree that has been created. Make a separate write up for each of these smaller risks associated with the fault tree or event tree. Your paper should have a general introduction that should introduce the decision tree and fault or event trees that will be discussed, and then the paper should have a discussion regarding each tree. The discussion write-up regarding the identified risks should be from three to five pages in length. Note that this page length is a guideline and if you find that your paper supporting the risk tree is longer, there will be no penalty, because the final assignment will need to be from 1520 pages in length.

Sample Outline of Typical Course Project Paper Part II

1. Course Project Part I
2. Introduction
3. Decision Tree Analysis
4. Discussion of Decision Tree
5. Fault Tree
6. Discussion of Fault Tree
7. Conclusions
8. Works cited

Objective

The goal of the final project is to select a project and then to create and detail a risk management plan that would support that project. The final deliverable will consist of a fully formed risk management plan that would support such a project.