Question: Hi I was able to break down into address using these range (refer to Figure 1 ) and I already filled out the tables figure
Hi I was able to break down into address using these range (refer to Figure 1) and I already filled out the tables figure below mentioned (refer to Figure 4). On Phase 1: Requirements, Sample logical diagram, since I've have already filled in VSLM inside the already so you can refer it. But now is my Sample logical diagram, so before i do anything else, I label down & each router interfaces so that when configuring the routers in packet tracer later (Refer to Figure 5) Could you help me check if my labeling is correct on diagram (Refer to Figure 3)








Given address range 201.30.10.0/24 Subnet address to Internet router 220.220.200.0/30 Admin 40 Remote Sale 20 Engrg 16 Max server 3 OSPF Process ID 70
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
