Hi please use the given information to explain each part of the practice problem and please include any drawing, or steps/formulas to improve my understanding of the problem if necessary. Thank you! Please DON'T repost response from other similar question posts. Will thumbs up for any helpful work! :)

Free-body diagrams, and equilibrium Consider the assembly shown in Figure 5.1, consisting of Beam AB, post CD and cable EG. Note that other details of the situation are given in the figure caption. (a) Create free-body diagrams of the Assembly (shown in Figure 5.1) and the Assembly's component parts (shown in Figure 5.2). Make sure to draw consistent forces between the sub-parts. (b) Inspect your free-body diagrams in (a). How many unique unknown loads are contained in these diagrams? (List them). (c) Does your free-body diagram representation of member EG depict it being in tension or compression? (d) Set up the equilibrium equations for beam AB. Solve for unknown loads. Hint: Using A as the moment center is helpful because it eliminates an unknown load from the moment balance. (e) Set up the equilibrium equations for post CD Solve for unknown loads. 2 m C 4 m G 0.75 m 50 DFigure 5.1 A bar AB weighing 1000 N is supported by a post (CD) embedded in the ground and a cable. The post weighs 250 N. Assume that all surfaces are smooth and that member E0 acts like a tum-force member. Fl re 5.3 Members of the assembl sn [into com neat . In addition: o be consistent in drawing the loads, 0 state the given quantities - state assumptions