I have a microcontrollers project where I have tp design something on proteus and code it using microC. the microcontroller used should be the pic$16$f$887.$I need you to build the project for me and share with me the proteus file and the code. please share screenshots of the project as well. the requirement are as follows: Design a circuit that controls the level and temperature of water in a tank as per the following requirement:

A level sensor will output $0$ while the water is below it and $1$ while the water is above it$.$

Two level sensors are placed at the $50\%$ mark and the $90\%$ mark of the tank.

If the water level goes below the $50\%$ mark the water bump turns on to fill the tank.

The water bump turns off when the water reaches above $90\%$ of the tank.

Initially, the water tank is full.

Use switches to represent the level sensors$.$

Use a DC motor to represent the water bump.

A temperature sensor outputs a value between $0$ to $5$ volts to represent the temperature of the water.

$0$ volts represents $20$ and $5$ volts represent $30($i$.$e$.0\mathrm{.}5$ volt increment $=1$ degree increment$)$

When the temperature gets above $27$ a fan is turned on to cool the water.

When the temperature is below $23$ the fan is turned off.

Use a Potentiometer to represent the temperature sensor$.$

Initially, the water temperature is $25.$

Use a DC Fan to represent the fan.

Add one extra feature to the project without affecting the work of the previously mentioned features. The feature could be an additional component in the circuit, or an additional functionality made through the code without changing the circuit. However, please make sure the extra feature fits the theme of the project and not some random extra LED.

the switch used is the sw$-$spdt