Direction: 1. Form a group of 3 and perform the simulation below: PROBLEM 1 Considering the positional sketch below, design the equivalent electropneumatic circuit in FLUIDSIM where the cylinder will only extend and retract after 2seconds. The whole process must be repeated 4 times. Positional Sketch: 00 Contol Panel H I 0 Note: 52 initially energized ST 12 a. Design the equivalent electrical and pneumatic circuit. (25 Marks) b. Using FESTO modules/FLUIDSIM develop the equivalent electro-pneumatic circuit. (25 Marks) c. Simulate the sequence based on the given conditions. (25 Marks) Interpret the and shown d. result output (10 Marks) e. Prepare laboratory report with the following parts: (15 Marks) Explain the function of pneumatic and electrical devices based on the given specification. Write an analysis how latching on relays were used in the execution of the sequence. Explain the logical function that was executed by the relays during operation. Write a conclusion regarding the principles applied in the simulation.