I need help using a UART to read a char in PLP assembly

The following files are given. Only get_char should be modified:

Need to fulfill the following requirements:

Polling Loop: Reading Status Register	The value of the status register is successfully read into a register
Polling Loop: Reading Status Register	The value read from the status register is masked to isolate the ready bit
Polling Loop: Condition Check	A loop is created through control flow instructions where the loop is only exited if the status register's ready bit is set
Receive Buffer Read	The receive buffer is successfully read after exiting the polling loop
Write Clear Status	A clear status command is successfully written to the command register after a character has been read from the receive buffer

Example Run:

PLEASE ANSWER WITH CODE FOR get_char OR THUMBS DOWN THANK YOU IN ADVANCE LOVE YOU

main.asm > get_char.asm:9 IART at oufo000000 Ascil 5 ting Send Q Watcher Display Value As: Padied 4 ASCil characters